LSI 3ware SAS 9750-8i Guia do Utilizador descarregar pdf (Página 99)

Viewing Information About a Phy

www.lsi.com/channel/products 87

To enable or disable spinup and set the delay between spinups

1 At the main 3BM screen,

Tab to Policy and press Enter.

2 On the Policy

Control screen, Tab through these fields, making the

choices you want to use:

•

Staggered Spinup: Choose enabled or disabled.

•

Number of Drives Per Spinup: Select the number of drives,

depending on the number of ports on the controller.

•

Delay between spinup: Select the number of seconds—from 1 to 6.

Tab to the OK button and press Enter.

You will notice a short delay as 3BM makes the policy changes.

Viewing Information About a Phy

The 3ware 9750 RAID controller has 8 phy transceivers (phys) that receive

and transmit the serial data stream between the controller and drives and other

devices in the SAS domain.

Phys are associated with the SAS ports on the controller. Multiple phys can be

associated with one SAS port, which is then called a “wide port.” In the 9750,

there are two wide ports and each wide port has 4 phys.

You can check the phy properties on the Controller Phy Summary page.

To see information for a phy in 3DM 2

1 Select the controller for which you wish to view phy information from the

drop-down list on the menu bar.

2 If you have a direct-attached drive you can access the Controller Phy

Summary page from the

Information > Drive Information page by

clicking the phy ID for the drive. Otherwise, navigate to the

Management

> Controller Settings

page.

Note: It is possible to enable or disable automatic detection of drives on the

controller’s ports for staggered spinup during hot swapping of drives. This feature is

only available in the CLI using the autodetect=on|off command. For more

information, see /cx set autodetect=on|off disk=<p:-p>|all 3ware SATA+SAS RAID

Controller Card CLI Guide, Version 10.0.

Note: Some hard drives require that the power management jumper (PM2) be set

to enable staggered spinup, in order for the SATA OOB option to be used. For more

information, search the LSI Knowledge Base for keyword 14889 (use the Advanced

Search) at https://selfservice.lsi.com/service/main.jsp

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 341 342

Comentários a estes Manuais

Vikivzn 04 Jan 2024 | 17:05:44

urenrjrjkvnm

Evazoy 07 Jan 2024 | 01:42:43

Med

Renatimzn 07 Jan 2024 | 09:55:43

urenrjrjkvnm

Davidvmm 10 Jan 2024 | 11:36:21

coin

Davidefb 11 Jan 2024 | 11:24:30

coin

Viktorijsw 11 Jan 2024 | 19:38:33

Cinema

LSI 3ware SAS 9750-8i Guia do Utilizador Página 99

Comentários a estes Manuais